SICOTRONIC 2020
Our cost-effective and powerful energy optimization system

LON display and operating module ABM2020:
The 2020 kitchen optimization system consists of the display and operating module ABM and up to eighteen electrothermal and eight general electrical circuits with a kitchen-specific control program.
Thanks to LON-BUS technology (FTT10), all modules can also be mounted up to 600 m away from the display unit. EAM-N and REL-N can be lined up by means of a concealed BUS power connector, can be completely mounted on top-hat rails and are therefore inexpensive and easy to install.
The display and control unit has an interactive, comfortable menu navigation via 5 buttons and a 1.3 inch OLED display. The actual configuration and programming takes place via a web interface. The power measurement in the infeed takes place either via current transformer and two-wire LON-BUS measuring transducer (MUGMCLON) or via quantity pulse (EAM-IMP).
Also suitable for installation in stove block distribution boxes.
product name: ABM2020
Module variants
Thermal consumers
Just like every cook, the SICOTRONIC central unit monitors the respective thermostat status (and of course the on and off status of the device switch) of switched on devices and counts the individually and currently elapsed operating seconds. The heating-up phase, continued boiling phase, loaded and unloaded thermostat cycle are reliably detected and evaluated. To avoid production disruptions in individual devices, the shutdown periods are computer-controlled and automatically reduced to a minimum, depending on the load ratio, device type, current usage and production phase and thermostat cycle.
To avoid production disruptions in individual devices, the shutdown periods are computer-controlled and automatically reduced to a minimum, depending on the load ratio, device type, current usage and production phase and thermostat cycle.
product name: EAM-N
LON active power transmitter
The multi-function transmitter MUGMCLON measures the three phase currents and the three associated phase voltages. From this, it determines the active power P in kW and makes this available to the LON network, as well as the three measured phase currents in A. The currents are displayed as negative or positive depending on the direction of flow, which can be used to check the installation or monitor the phase failure.
product name: MUGMCLON
SO volume pulse measuring module
The LON module EAM-IMP measures the quantity impulses of the EVU and calculates the output in kWh. This value is transferred to the ABM. The pulse module has SO interfaces (quantity pulse, tariff switching) on a 5-volt basis.
product name: EAM-IMP